Sulfur pastillator AS15000

Application:
Low melting point materials (usually refers to melting point in the materials between 50-300 ℃) in a molten state can be mobile, in a solid state at room temperature.
Typical applications materials: sulfur, paraffin wax, rubber, resin, pitch, maleic anhydride, TMA, satiric acid products, thermal Sol, phenylenediamine, urea, plastics additives and so on.

Performance advantages:

■   Uniform particle shape and size is conducive to transport, packaging ,  the use ,  the production and use of the process operating conditions and the improvement of the environment, improve product quality and competitiveness.
■   Heat a thin strip and atomizing spray forced cooling, hot-melt was expected to be rapid condensation, curing, productivity increased significantly.
■   Cooler system and dropform system are used Frequency Control device drivers, according to production capacity and material properties no-conditioning control.
■   A smart temperature controller distribution of the temperature control to ensure that the material temperature and material properties of stability, the quality of granulation reliable protection.
■  Discharge side of the strip for the bending, curing particles and the combination of surface strip easy peeling off, discharging dust when little, particle shape is protected, while also reducing the scraper when the impurity content into the product.
■  Sub used cooling, according to materials condensation, curing characteristics, the choice of the cooling temperature, special materials to achieve rapid cooling, curing extremely favorable
■   Sharpnozzle granulation systems in its structure using removable portfolio structure, according to material properties and production equipment specifications choice is conducive to large-sized transport and installation of devices.

Main advantages:   

● Reduce dust, improve the operating environment;  Continuous operation to improve production efficiency;  Grain is neat, commodity value is promoted.  

● Using thin steel belt heat transfer and forced spray cooling, so that the hot melt material can be cooled quickly, solidified molding.  

 ● Due to the reversing bend of the steel belt at the discharging end, the joint surface of the solidified material and the steel belt is separated, and the dust is very little when discharging, and the particle shape is completely protected.  

 ● Steel belt and distributor adopt frequency conversion speed regulation, which can be easily adjusted and controlled according to production capacity, environmental conditions and physical properties.  The device can also be widely used in the rapid cooling process of powder materials and cake sticky materials, such as emulsion explosive matrix, crystal stone matrix, sodium fluorosilicate, etc. 

Model:

Working principle of equipment